
28
The camera name is reserved for customer use.
Select the streaming mode.
1. TCP only
2. Multicast only
3. RTP Over UDP
4. RTP Over Multicast
5. RTP Over UDP & Multicast
Check box to enable RTP streaming’s Account/Password
authentication.
Check box to enable the B2 frame in RTP streaming
Select to enable or disable the audio function.
Select the multicast IP. Default settings is 228.5.6.1
Select the multicast TTL. Default setting is 255.
This option appears only in Multicast. Enabling it will
enable using IGMP membership to do multicast.
This colum shows the Analog Video standard of this
device. This is not changeable
Select the video resolution of the IP device.
Select the frame rate mode.
Constant: The streaming’s frame rate remains
constant at all conditions.
Variable: The streaming frame rate will vary
according to the amount of motion and change
in the scene to maintain proper image quality.
Select the frame rate of the video streaming.
Select the encoder’s compression type.
1. MPEG4
2. MJPEG
Select the video bitrate mode.
Constant Bit Rate: The streaming’s bitrate remains
constant at all conditions. The quality will vary slightly
according to amount of motion in scene.
Variable Bit Rate:: The streaming bit rate will vary
according to the amount of motion and change in the
scene to maintain image quality.
Video Quality: Select video quality between High, Middle
and Low.
GoP Length: Number of frames between I Frames.
Select the Maximum bitrate of the video streaming.
If the bitrate limit is too low, actual frame rate may also be
limited. Doing so will also disable Bit Rate setting below.
Select the bit rate of the video streaming. You can select
from 28Kbps to 3Mbps.
Note: Lower bit rate consumes less bandwidth but
delivers lower quality images.High bit rate
consumes more bandwidth but delivers higher
quality images.
Kommentare zu diesen Handbüchern