ACTi E66 Installationsanleitung PDF herunterladen (Seite 17)

E-17



 USB Cable Holder Installation

This holder prevents the USB cable from becoming disconnected due to vibration,

etc. Place the PS-A unit face-down on a flat surface as shown below. Your PS-A

unit has two USB connectors.

• When using both USB connectors, be sure to first connect one USB cable to

the lower USB connector, then connect the second USB cable to the upper

USB connector.

• When using only one of the USB ports, be sure to use the lower USB connec-

tor. This allows you to securely clamp the USB cable in the cable clamp.

Upper USB Interface

Lower USB Interfac

USB Cable

Clamp

Band

Bridge

able Collars



Clip

Clamp

[Attachment]

As shown below, insert the USB Cable Clamp’s band through the Bridge. Pass the

USB cables through the Cable Clamp’s band and securely tighten the clamp band

around the cables.

• Be sure the clamp is securely holding the USB cable’s plug and collar.

• Be sure the clamp is positioned as shown below, with the clamp pointing

upwards – not to the side. This is to keep the clamp from interfering with

nearby connectors and their cables.

[Removal]

To remove the clamp from the USB cables, push down on the clamp strap’s clip to

release it while pulling up on the clamp.

1 2 ... 12 13 14 15 16 17 18 19 20

Keine Kommentare

ACTi E66 Installationsanleitung Seite 17