2013/12/06 Outdoor-Ready Box Mounting on a Vertical Pole using the Accessory Set Installation Guide For Models: KCM-5511 / KCM-561
www.acti.comInstallation Guide 10 Step 6: Install the Camera 1. Align the screw holes of the holder to the bottom screw holes of the camera.
www.acti.comInstallation Guide 11 4. Loosely attach the screw to secure the holder to the bracket. 5. As needed, turn the holder left or right
www.acti.comInstallation Guide 12 Step 7: Access the Camera Live View Connect the other end of the Ethernet cable to a PoE switch and access the c
www.acti.comInstallation Guide 13 Appendices This section describes the procedures in preparing the external devices that you can connect to the c
www.acti.comInstallation Guide 14 3. Connect the wire with the white stripe to the 12V pin and the other to the GND pin. 4. Tighten the scr
www.acti.comInstallation Guide 15 Connecting DI/DO Devices (Optional) Depending on your surveillance needs, you may connect digital input or outpu
www.acti.comInstallation Guide 16 To connect input devices (DI), map the pins to one of the pin combinations below: Device Pin Mapping Instructi
www.acti.comInstallation Guide 17 High Voltage DO Device Connection Even though the camera provides 12V power, this may not be enough for some hi
www.acti.comInstallation Guide 18 Connecting a Serial Device (Optional) The camera can be connected to a Pan-Tilt (PT) Scanner (Pan-Tilt Head) usi
www.acti.comInstallation Guide 19 CAUTION: Incorrect wiring may cause damage to the connected devices. DISCLAIMER: ACTi will not be responsibl
www.acti.comInstallation Guide 2 Table of Contents Installation Procedures ... 3 Step 1: Attach
www.acti.comInstallation Guide 20 Safety Information Read these instructions You should read all the safety and operating instructions before usin
www.acti.comInstallation Guide 21 Damage Requiring service Disconnect this video product from the power supply immediately and refer servicing to
www.acti.comInstallation Guide 3 Installation Procedures This section provides step-by-step procedures in installing the camera on a vertical pole
www.acti.comInstallation Guide 4 3. Do steps 1 and 2 to the other wire strap. 4. Position the pole mount with the cable path up and encircle t
www.acti.comInstallation Guide 5 Step 2: Install the Bracket 1. Remove the screw to detach the camera holder from the bracket. Set the holder asi
www.acti.comInstallation Guide 6 Step 4: Prepare the Flex Conduit 1. From the network side, insert the Ethernet cable and other cables (if any) t
www.acti.comInstallation Guide 7 4. Insert the sealing insert and attach it at the end of the flex conduit. 5. Detach the conduit gland
www.acti.comInstallation Guide 8 7. Insert the sealing insert into the conduit gland body. 8. Attach the clamping nut to complete the cabl
www.acti.comInstallation Guide 9 Step 5: Connect the Ethernet Cable 1. Connect the Ethernet cable to the Ethernet port of the camera. If conne
Kommentare zu diesen Handbüchern